The dimensions of the surface, its geometry, exposure and the behavior of the substrate determine the need for and the distribution of expansion joints for tiles. Attention increases above all on large surfaces and installations with large formats, in outdoor environments and in floors laid over heated screeds.
Outdoors, direct solar radiation, temperature swings, frost and climatic variation subject the system to more severe conditions. Expansion joints in outdoor floors must therefore be assessed in relation to orientation, the geometry of the bays, the dimensions of the surface and the conditions of exposure. A floor in full sun or developed in an irregular shape may in fact require a different management of movements compared with an interior surface in more stable conditions.
In floors with radiant heating, the correct arrangement of the joints takes on particular importance because the thermal cycles act directly on the screed. The layout of the system, the joints present in the substrate and the tile pattern must be read together, avoiding designing the ceramic installation as an independent layer.
In this specific context, as a general reference, bays of the order of 20–25 m² may be provided, separated by joints no less than 5 mm wide, formed in the screed and carried through into the floor. These values do not constitute a rule valid for any floor: the frequency, position and width of the joints must be defined according to the configuration of the screed, the geometry of the surface, the size of the tiles and the specific conditions of installation.
How many meters apart should expansion joints be provided in a floor? This is a frequent question, but the distance cannot be defined through a single linear value valid in every situation. It is more correct to reason in terms of bays, because a square surface, a long narrow corridor or an area interrupted by pillars and openings distribute movements differently.
The same principle applies to depth. A joint that involves the screed and a movement space provided for in the covering alone do not have the same configuration: it is necessary to respect the layer that the joint is called upon to interrupt and the geometry planned for the elastic material or the profile used. Filling the space with adhesive or rigid grout would instead compromise its capacity for movement.